AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
and when installing the new one in, i didn't have to do anything taping just put it through making sure there is no censored on the spindle and BB shell and the bearings. When i removed my BB30 cranks i just had to tap the non-drive side of the spindle (once the non-drive side crank is removed). a bit of locktite might do the job however you will have a job of it in removing the bearing afterwards. did it give u much resistance? if not, the bearing might be undersized or your shell is oversized slightly. In our channel you can find both product videos showcasing and describing our products, together with how to videos describing key installation and maintenance procedures. When you first pressed in the BB30 bearing was it tight? i.e. The bearing is suppose to fit tight to the shell and lock the shell and bearing in place so it doesn't move.then the ball bearings allow movement between the spindle. you should have greased the machined parts on the crank spindle where it will meet the bearing. You shouldn't have put grease around the outside of the bearing ring. At the bottom are links to the installation manuals for the crankset - this should tell you what you. the spring washer is like a buffer basically to reduce the axial load on the bearings when tightened. Road Cycling - Remove FSA GOSSAMER Crankset BB30. There shouldn't be any lateral movements at all.
0 Comments
Read More
Leave a Reply. |